Ero sivun ”Matkapuhelin modeemina/Elisa” versioiden välillä
Siirry navigaatioon
Siirry hakuun
(→/etc/ppp/peers/elisa: otsikko oli jääny source-tagin sisään) |
|||
(Yhtä välissä olevaa versiota toisen käyttäjän tekemänä ei näytetä) | |||
Rivi 98: | Rivi 98: | ||
<source lang="bash"> | <source lang="bash"> | ||
#!/bin/sh | #!/bin/sh | ||
exec chat | exec /usr/sbin/chat \ | ||
TIMEOUT 5 \ | TIMEOUT 5 \ | ||
ECHO ON \ | ECHO ON \ | ||
Rivi 135: | Rivi 135: | ||
* [http://forum.ubuntu-fi.org/index.php?topic=9055.msg69699#msg69699 Ubuntu-fi.orgin keskustelupalstan käyttäjä brownie] | * [http://forum.ubuntu-fi.org/index.php?topic=9055.msg69699#msg69699 Ubuntu-fi.orgin keskustelupalstan käyttäjä brownie] | ||
[[Luokka:Suomi]] | |||
[[Luokka:Verkko]] | [[Luokka:Verkko]] |
Nykyinen versio 10. syyskuuta 2011 kello 17.56
Asetustiedostot, joiden avulla matkapuhelinta voi käyttää modeemina Elisan liittymiä varten:
Tällaisenaan asetukset käyttävät puhelinta Bluetoothin kautta. Mikäli haluat käyttää datakaapelia, kommentoi rivi "/dev/rfcomm0 # Bluetooth device file" ja poista kommentti rivin "#/dev/ttyACM0 # Data cable device file" alusta.
/etc/ppp/peers/elisa[muokkaa]
# Most GPRS phones don't reply to LCP echo's
lcp-echo-failure 0
lcp-echo-interval 0
# Keep pppd attached to the terminal:
# Comment this to get daemon mode pppd
nodetach
# Debug info from pppd:
# Comment this off, if you don't need more info
debug
# Show password in debug messages
show-password
# Connect script:
# scripts to initialize the GPRS modem and start the connection,
connect /etc/ppp/elisa-connect-chat
# Disconnect script:
# AT commands used to 'hangup' the GPRS connection.
disconnect /etc/ppp/elisa-disconnect-chat
# Serial device to which the GPRS phone is connected:
#/dev/ttyACM0 # Data cable device file
/dev/rfcomm0 # Bluetooth device file
# Serial port line speed
115200 # fast enough
#57600
# Hardware flow control:
# Use hardware flow control with cable, Bluetooth and USB but not with IrDA.
crtscts # serial cable, Bluetooth and USB, on some occations with IrDA too
#nocrtscts # IrDA
# Ignore carrier detect signal from the modem:
local
# IP addresses:
# - accept peers idea of our local address and set address peer as 10.0.0.1
# (any address would do, since IPCP gives 0.0.0.0 to it)
# - if you use the 10. network at home or something and pppd rejects it,
# change the address to something else
0.0.0.0:0.0.0.0
# pppd must not propose any IP address to the peer!
noipdefault
# Accept peers idea of our local address
ipcp-accept-local
# Add the ppp interface as default route to the IP routing table
defaultroute
# DNS servers from the phone:
# some phones support this, some don't.
usepeerdns
# ppp compression:
# ppp compression may be used between the phone and the pppd, but the
# serial connection is usually not the bottleneck in GPRS, so the
# compression is useless (and with some phones need to disabled before
# the LCP negotiations succeed).
novj
nobsdcomp
novjccomp
nopcomp
noaccomp
noccp
# The phone is not required to authenticate:
noauth
# Username and password:
# If username and password are required by the APN, put here the username
# and put the username-password combination to the secrets file:
# /etc/ppp/pap-secrets for PAP and /etc/ppp/chap-secrets for CHAP
# authentication. See pppd man pages for details.
user "rlnet"
password "internet"
#
mtu 1500
mru 1500
asyncmap 0xa0000
/etc/ppp/elisa-connect-chat[muokkaa]
#!/bin/sh
exec /usr/sbin/chat \
TIMEOUT 5 \
ECHO ON \
ABORT '\nBUSY\r' \
ABORT '\nERROR\r' \
ABORT '\nNO ANSWER\r' \
ABORT '\nNO CARRIER\r' \
ABORT '\nNO DIALTONE\r' \
ABORT '\nRINGING\r\n\r\nRINGING\r' \
'' AT \
OK ATH \
OK ATE1 \
OK 'AT+CGDCONT=1,"IP","internet","0.0.0.0",0,0' \
OK ATD*99# \
TIMEOUT 22 \
CONNECT ""
/etc/ppp/elisa-disconnect-chat[muokkaa]
#!/bin/sh
exec /usr/sbin/chat -V -s -S \
ABORT "BUSY" \
ABORT "ERROR" \
ABORT "NO DIALTONE" \
SAY "\nSending break to the modem\n" \
"" "K" "" "K" "" "K" "" \
"+++ATH" "" "+++ATH" "" "+++ATH"
Oikeudet[muokkaa]
Tiedostoilla on oltava suoritusoikeudet:
chmod +x /etc/ppp/elisa-*